AutoDyn 30 AWD - AC
The 42-inch roll two-wheel-drive AutoDyn chassis dyno is our highest-capacity chassis dynamometer. It features 42-inch (107 cm) diameter rolls for minimum tire deflection and maximum contact patch size. Torque is measured with a temperature-compensating load cell for precise torque and power readings. You can place this chassis dyno above or below ground for testing.
This 42-inch roll AutoDyn chassis dyno can run a variety of built-in vehicle tests, including single-gear or all-gear tests at wide open throttle. Controlled acceleration, controlled deceleration, step, steady-state, aero load, and drive cycle tests can be easily run with the included eddy current power absorber module. The steady-state and drive cycle tests can be performed at full or partial throttle settings.
The SuperFlow Sensor box monitors and measures the data from the AutoDyn chassis dynamometer and comes ready to run the eddy current brake. You can add a variety of accessories to our sensor box, including temperature measurement, pressure measurement, and air/fuel monitoring.
Each AutoDyn chassis dyno is shipped with SuperFlow's handheld controller, ignition sensor clip, optical tachometer, and WinDyn™ software package. Eight hours of training are included in the price*.
* Labor cost for training is included in system price. Travel costs, travel time and expenses not included.- Air-actuated roll lock
- Upgradeable to single or dual eddy current power absorber(s)
- Upgradeable to all-wheel-drive
- Bi-directional test capability
- Stand-mounted data acquisition and control system with four liquid crystal displays
- Two lambda sensor inputs (sensors not included)
- Six expansion bays (for optional thermocouple, pressure, voltage input modules)
- Handheld system control and display unit
- Inductive ignition sensor clip with adjustable gain.
- Optical tachometer
- Real-time weather station (air temp, barometric pressure and humidity)
- Pit kit included.
- WinDyn™ software package
- 16 hours of training**
- One-year warranty, including parts and labor***
** Labor cost for training is included in system price. Travel costs, travel time and expenses not included. Actual travel expenses are billed upon completion of training. Inertia only units receive eight hours of training.
*** Does not include travel cost, travel time, and expenses.
| Roll Diameter | 30" (76.2 cm) |
| Peak Power | Depends on type of testing |
| Peak Absorbed Power | Depends on type of testing |
| Max Speed | Depends on type of testing |
| Track Width | 26" inside - 100" outside (66 cm - 254 cm) |
| Wheelbase | 92" - 131.5" or 100.5" - 140" (234 cm - 334 cm or 255 cm - 356 cm) |
| Base System Inertia | Full Electric Inertia Simulation |
| Axle Weight | 8,000 lbs. per axle (3,629 kg) |
| Air Requirements | 50 - 100 psi (345 - 690 kPa) |
| Power Requirements | Depends on size of AC Motor |
| Shipping weight(approximate) | 12,500 lbs. (5,670 kg) |
